Skip to main content
Open search engine
Search
Close search engine Clear Search
Products in the cart: 0. See details
Your cart is empty

Dimensional tolerances for pipes and hollow bars

 

Dimensional tolerances acc. To EN ISO 1127

Outside Diameter Wall Thickness
tolerance class allowed deviation tolerance class allowed deviation
D1 +/- 1,5%
min +/- 0,75 mm
T1 +/- 15%
min +/- 0,60 mm
D2   +/- 1%
min +/- 0,50 mm
T2 +/- 12,5 %
min +/- 0,40 mm
D3 +/- 0,75%
min +/- 0,30 mm
T3   +/- 10%
min +/- 0,20 mm
D4 +/- 0,50%
min +/- 0,10 mm
T4   +/- 7,5%
min +/- 0,15 mm

 

 

Dimensional tolerances acc. To EN 10305 ( precise)

Outside Diameter Tolerance
4≤D≤30 ±0,08 mm
30<D≤40 ±0,15 mm
40<D≤50 ±0,20 mm
50<D≤60 ±0,25 mm
60<D≤70 ±0,30 mm
70<D≤80 ±0,35 mm
Wall thickness tolerance

±10,0%
(minimum ± 0,1 mm)

 

Tolerances for stainless steel hollow bars according to ISO 2938

Stainless steel hollow bars are metallurgical products intended primarily for further machining. Their dimensions are subject to tolerances typical of metallurgical products, not to the tolerances of mechanical fits. Actual tolerances may vary depending on the manufacturer, production technology and material batch. The most common manufacturing tolerances are listed below.

Parameter Typical tolerance
Outside diameter (OD) 0 / +2%
min. +1.0 mm
Inside diameter (ID) -2% / 0
min. -1.0 mm
Wall thickness min. 95% of nominal thickness
Eccentricity max. 10%
Straightness max. 1 mm / 1 m

The outside diameter tolerance is positive and the inside diameter tolerance is negative, so the hollow bar provides a machining allowance. For applications requiring precise fits, the dimensions must be brought to the required accuracy class by turning, boring or grinding.

 

Please note that the specified tolerances apply to full bars and that the control measurement is made at the ends of the pipe. When purchasing unprefabricated sections other than those listed in the production certificate for a particular batch, deviations from the values given in certificate 3.1 may be expected and may not be a basis for considering the product as not meeting the requirements of the standard or as being of inferior quality.